Short update: I checked the wiring again, everything seems OK. It even works with the DIO modules.... Weird.

Hello Nicolai, thank you for your answer. The first module was bought via your web shop. The second module via Conrad, because you don't have any stock atm. I am still waiting for an answer from Conrad about the sent back module. I attached a picture of the wiring. The signal from the DO module (pur...

Hello there, We've got some very weird problems going on with the DO module. It seems like the module is not able to switch the lower half of the outputs correctly. They are used to switch Phoenix Contact Relais . After some time the first module we used decided to die spontan spontaneously and viol...

Okay, I just made a new project and now it kinda works - sometimes it's the most obvious things which help ;) . The Can-Device on my Bus is working, but the Kunbus mGate thing not ( SDO protocol timed out, red alert sign). Because of this, the CANopen Manager is unhappy aswell, telling me that CANop...

Hello there, I already had some issues with the ConCAN-Device a while back, but this was before the official Codesys-Support was there. Now, I can't use it again - Codesys detects the module on the right, Pictory aswell but the CANbus/CANopen_Manager/KUNBUS_mGate throw the error "NetID 1: No CA...

Hello Amar,

Thank you so much for the demo project and the description! This helped me a lot.

All the best

Hello there, I've been trying to use the ConCAN module with the new Codesys library, but sadly it is not possible (for me). It seems like others have problems aswell, but at least Codesys detects it. I found out that it is not possible to configure it with Pictory, but with Codesys - you need to att...

I attached a ConCAN module on the left side of connect module. But, when I tried to run the program, a red triangle appears on the left side of the ConCAN module which means Codesys cannot find the ConCAN module. Hello, You need to attach it to the right side of the connect, you have to do the same...

Okay, I solved the issue. You are not allowed to configure it with Pictory, when using the new library version. If you add the device "to the right" via Codesys, it seems to work.
But does it behave like a master this way? The "offical" guide is completely different.

All the best

Hello, I have the very same problem. I already configured a DIO module but now I want to add a ConCAN module. It is possible to add it in pictory, after saving the config and resetting the driver it shows up. piTest -d also shows the module - but if I restart the Revpi, it disappears. When i stop Co...