Hi Amar,

It is a little bit late but we have followed the tutorial.
We have also a codesys package from the developer of the frequency generator and now everything is working fine.

so I would thank you for the great support!

Best regards,

Jeroen

Hi Amar, Thank you for the response. We have setup the modbus master and slave with the tutorial on revpiCodesyslibHelp. When we run the programm the slave has an error that the bus is not running (error no response time). we don't know exactly what is going wrong we have followd the tutorial and im...

Hi Amar, Thank you for the great support. I have downloaded a new version of Codesys with your Revpi package and it works again without any error. But I have one other question. We are currently with the revpi core 3 working on a school project. And we need to control the conveyorbelt with a frequen...

Hi,

So when I start up codesys it says 3.5 v10 so I need to download the latest version of codesys on the website from codesys?
And where can I find the CHM help file there is only a package file and when I open this my codesys crashed.

Best regards,

Jk#312

Hello Anwar, Thank you for the reply. But when I download the file and go to codesys to package manager and install it and try it again codesys is reporting that the file is installed. So when I then build our programm codesys shows the error message below. Is there something wrong with our programm...

Hi Dirk,

I could not download the file it has error 404 I have tried it a copple of times. But the download link never worked.
Sorry for the late reply I had a very bussy time at school.

Hopefully you could help me again.

Greets
Jeroen

Hi Dirk, We have a question about the revpi lib package. We wanted to test the outputs of our program but when we used putty we could activate the outputs and it works. But when we use codesys the outputs won't activate they give 0 V. In a comment above the new package would be available next week. ...

hello, I am new to this forum and working with the Revpi is also a new challenge. For a school project I want to use the kunbus Revpi core 3 with codesys. Now I have gone through the tutorial on the website to set up codesys. However, I get the following error message Failed to insert library IoDrvG...