ok, such a strange bug. Yes its DIO-AIO-AIO-DO, I will try to move the DO module to the right of the DIO and we'll see.

Hello, I have a setup with a revPi Connect+, two AIO, one DIO and one DO modules. In the outputs of the module DIO I have some ports configured as OutputPushPull and with default value as 1. In the DO also some ports are OutputPushPull and with default value 1. But after a reboot or a reset with piT...

Ok, now it's working, but not by using the console commands: 1) I've set the OutputPushPull to 65535 in the Pictory config. 2) I've selected 'Save as Start-Config' in the File menu 3)I've made a reset driver from the Tools menu. The voltage read at the output is 0.08V! As you said, writing to Output...

Hello Dirk, these are the commands that I'm sending: 1) Set to 1 all the bits of the OutputPushPull register: pi@RevPi30661:~ $ piTest -w OutputPushPull,65535 Write value 65535 dez (=ffff hex) to offset 195. 2) Set to 1 the output 11: pi@RevPi30661:~ $ piTest -w O_11,1 Set bit 2 on byte at offset 16...

Hello, I'm trying to manage some little 12v relays by using the outputs of an DIO module. I've been using the module without problems but only the high side function, wiring the outputs to 12V relays and activating them. Now I want to use the outputs to sink current, wiring the relay to 12V and putt...